ISSUE 15

In this issue you will be getting Pipework details (x 16), and the Power input unit (upper and lower halves)

  • Fitting The Pipework

The power input unit stuck together much better than intended. Putting in the first few pieces of piping is fairly easy and you should probably use tweezers. Steps 17 through 28 are a very big pain in the butt, because of the little plastic tubes that need to be in a certain direction so I would say to put them on the big piece before anything else. I usually say don’t use super glue but this time recommend it for the little plastic tubes. Overall the final piece looked very good compared to what it looked like in the images inside of the book/ magazine.

 

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Building the 1:18 scale Star Wars X-Wing from DeAgostini