ISSUE 24

In this issue you will be getting the Left and Right undercarriage door, Lower front engine casing, Hinge retainers (x 2), Gyro cone lower and upper halves, XW06 screws (x 9), Cooling vane, Upper shroud, Retro thrust nozzle, and the Lower rear engine casing.

In “Assembling The Engine” Steps 1 – 3 you will need the Lower Front Engine Casing, and the Retro Thrust Nozzle. So with these steps you are going to be putting together the Lower Front Engine Casing, and the Retro Thrust Nozzle. Also you need to make sure that the pegs and the holes are together and everything sits flush.

In Steps 4 – 11 you will need the Gyro Cone upper and lower Half, Upper Shroud, Horizontal Vane, and the Cooling Cane. So take the upper half gyro, and the horizontal vane and make sure that you get the correct side. Then the lower half goes onto the pegs of the upper gyro half. Then the cooling vane goes into the slot on the lower half.

In “Fitting The Doors” Steps 1 to 4 take the Lower rear engine casing. What you are gonna want to do is screw it onto the Engine mount but you need to make sure that the screws are flush and that the Engine casing is also flush.

In steps 5 to 15 you are going to need the Engine Mount, and the Undercarriage doors. In these steps you are going to need to make sure that the doors sit flush and that the screws are also sitting flush.

That is all there is for Issue 24!!

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Building the 1:18 scale Star Wars X-Wing from DeAgostini