ISSUE 25

In this issue you will be getting the Fission chamber upper half, Fission chamber mounting, Upper engine casing, and the Plant-on details (x 9).

In steps 1 through 3 you will need to get the Fission chamber upper half and the Fission chamber mounting. When you are putting the pieces together make sure the pins line up with the holes. When you put the pieces together make sure that they are sitting flush.

Also in steps 4 through 6 you are going to need the piece you just made and the Upper engine casing. When you put these pieces you need to make sure that the pines and slots are for sure together because if you don’t the next issues will be tough.

Okay so for the rest of the issue you are going to need the piece you just made and also the Plant-on details (x 9). So these pieces when putting them onto the piece just made is kinda difficult if you don’t have tweezers because it is hard to put them together. Also you should make sure that they are all in the correct spots because if not then they might break.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Building the 1:18 scale Star Wars X-Wing from DeAgostini