ISSUE 32

In this issue you will be getting the Laser cannon tubes, Laser cannon side details, Laser cannon tubes, Laser cannon jacket, Laser cannon housing (outer half), XW01 screws (x3), Laser cannon shoulder, Laser cannon rear end cap, Laser cannon front end cap, Lower forward fuselage side frames.

In steps 1 – 2 you will need the Laser cannon tube, Laser cannon shoulder, and the Laser cannon jacket. When putting these together the first pieces are the tube and the shoulder. When putting them together you should use a table to push them together. Then put the jacket over the other side.

In steps 3 – 4 you will need the Laser cannon side tubes and the Laser cannon side detail. When putting them together make sure you check to see which way the side detail is pointing on the picture.

In steps 5 – 6 you will need the piece just made, and the Laser cannon housing (outer half). When putting them together make sure that the pins line up because there is a circle and a rectangular hole that have matching pins.

In steps 1 – 6 you will need the cockpit frame that was made before, and the Lower forward fuselage side frames. When putting the frame together make sure that they are on the correct sides. So when putting them together make sure that they are fitting together. The pins in the aide frames are basically touching at the end of them.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Building the 1:18 scale Star Wars X-Wing from DeAgostini