ISSUE 34

In this issue you will be getting the Laser cannon tip, Laser cannon emitter, Laser cannon flashback supporter, Laser cannon suppressor mount halves, Fibre optic, and Fuselage frame cross-members (x 5) [you won’t be using the frame cross-members]

In steps 1 – 3 you are gonna use the Laser cannon emitter, and Laser cannon suppressor mount halves. When putting them together you are gonna line up the emitter with the slot in the halves and also line up the pegs in the halves.

In steps 5 and 6 you are gonna need the piece just made and the Laser cannon flashback suppressor. So when you put these together you are gonna make sure that the slot and the pin line up, I used superglue since it was loose but for you it may not be loose.

In step 6 you are gonna need the Fibre optic and the piece from the last issue. When you put these together it may be difficult to put the optic in the last piece but it should stick.

In steps 7 – 8 you are gonna need the piece just made and the Laser generator end piece. It is in the shape of a D so it should be easier to line up at the end of the generator.

In steps 9 – 11 you are gonna need the laser tube and the piece just made and the piece at the beginning of this issue. This step should be easy cause you are lining up the tube with the end of the generator. Then you are gonna use the suppressor at the end of the tube.

At the end you have this

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Building the 1:18 scale Star Wars X-Wing from DeAgostini