ISSUE 39

In this issue you will be getting the Trailing-edge conduit (x 2), Trailing edge wiring (x 2), Outer wing frame, Wing-root base, and some XW02 screws (x 3).

In steps 2 – 6 you will need the piece from last issue, and the Outer wing frame, and also some XW02 screws. When putting them together the frame lines up with a bunch of pegs on the outer sides of the skin, there will be two holes and that is where the screws go when they are lined up.

In steps 7 – 8 you will need the Wing-root base, and the piece just made. When putting them together there are pegs on the bottom of the base that line up with holes on the bottom of the skin.

In steps 9 – 19 you will need the skin and both of the Trailing-edges. When doing this it is easy to tell with the conduits and the directions because they go towards the Power couplings. The wiring it is the nubs on the side that go towards the edge of the wing.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Building the 1:18 scale Star Wars X-Wing from DeAgostini