ISSUE 40

In this issue you will be getting the Engine mount, Leading-edge support, Plant-on details, and some XW02 screws (x 2). Plus this issue is very very short.

In step 2 you will need the Plant-on details. When putting them together make sure that you pay attention to the size of the pegs.

In step 3 you will need the Plant-on detail, and the Leading-edge support. When putting them together there is a corner on the detail that the support has. For me it didn’t fit so we took the details apart then put the side with nubs on the top of it in first then the other detail.

In steps 4 and 5 you will need the piece just made and the Engine mount. Next to the curved edge there is a peg with a hole next to it where the support will go. When it is on there secure then you will take an XW02 screw and put them together.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Building the 1:18 scale Star Wars X-Wing from DeAgostini