ISSUE 45

In this issue you will be getting the Internal bulkhead, Dark grey pipe, Silver pipework details (x 8), Inner wing frame, Engine mount brace, Engine mount brace, Laser cannon cabin, XW02 (x 14), XW03 (x 5), XW04 (x 6), XW05 (x 5) screws.

In steps 1 – 4 you will need the wing assemblies from stages 39 and 41 and XW02 screws. When doing this the diagonal side on the wing goes on the gear of the other piece.

In steps 5 and 6 you will need the piece just made and the Engine mount brace. When doing this the side with the two holes goes on the bottom right side of the wing.

In steps 7 – 10 you will need the piece just made and the Inner wing frame and the Engine mount brace. When putting these together you put the wing frame on first then you put the brace over the frame.

In steps 11 – 13 you will need the piece just made and XW02 screws. When doing this a tip I have to to unscrew about 1/2 a turn, then screw it in.

In steps 14 – 16 you will need the piece just made and XW04 screws. When doing this it is the tip that I gave for the last step.

In steps 17 – 19 you will need the piece just made and the XW03 (red) and XW05 (blue) screws. When doing this it is the same as the last two steps. also the second image is missing a blue circle.

In steps 21 – 28 you will need the piece just made and the Laser cannon cable. When doing this you will need to carefully bend the end of the cable so that you don’t take the prongs out. When doing this you will probably want to use a screwdriver or pliers to get it behind the prongs.

FITTING THE ENGINE

In steps 1 – 9 you will need the engine from stage 44 and the piece just made. When doing this you need an XW02 screw to make sure it is together and also the tip from before with the screw.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Building the 1:18 scale Star Wars X-Wing from DeAgostini