ISSUE 46

In this issue you will be getting the Power input unit (upper &lower halves), XW01 screws (x 2), and the Pipework details (x 16).

In steps 1 and 2 you will need the Power input unit upper and lower half. When doing this make sure the round end on both sides line up.

In steps 3 you will need the piece just made and one of the pipework details. When doing this it is the smaller pipework detail and then there is a D peg and hole on both the pieces.

In steps 4 – 6 you will need the piece just made and 2 pieces of the Pipework details (longer pieces). When doing this the side with the 4 holes goes toward the end and the other side goes into the holes of the piece just put on the last step.

In steps 7 – 12 you will need the piece just made and more Pipework details. When doing this I put the plate on before I actually put the other pipes on. When you put the pipes on put it on the plate first then the pipes.

In steps 13 and 14 you will need the piece just made and the arched pipework. then there are more pieces on the power input unit and that is where it goes.

In steps 15 – 18 you will need the piece just made and Pipework details. When doing this the side with the squiggly goes on the lower two and the one that is strait goes on the top.

In steps 18 and 19 you will need pieces from issue 45. Wen doing this the dotted side of the smaller pieces toward the inside.

In step 20 you will need the piece just made and other pieces from last issue. The piece just made where the new pieces will go, and one has a D shape while the other one doesn’t.

In step 21 you will need the piece just made and the last piece from last issue. When doing the I would recommend to be careful when putting it in since it is a very thing piece of plastic.

In step 22 you will need the piece just made and the piece from earlier this issue. When putting them together look carefully at the way the hole and nub line up.

In steps 23 – 25 you will need the piece just made and the extra pipework. When doing this the pipes are different then the actual book. A and B are ok but C and D should be switched with E and F and E should be C while F is H, and G is D and the H is G.

In steps 26 – 29 you will need the piece just made and the wing from Issue 45. When putting the piece just made in it has to go down then slide into place. When that is done you use an XW01 screw to mount it into place.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Building the 1:18 scale Star Wars X-Wing from DeAgostini