ISSUE 48

In this issue you will be getting the Lower skin, Outer edging strip, Inner edging strip, and XW02 screws (x 4)

In steps 1 – 6 you will need the piece from last issue and the Outer and Inner edging strip. When doing this the pegs go toward the end of the wing for the outer. The inner is the one that goes toward the back of the wing.

In steps 7 – 13 you will need the piece just made and the laser cannon and XW02 screws. When doing this I would recommend to put the laser cannon on with the wire then screw it in then hook up the wires.

In steps 14 – 16 you will need the piece just made and the Lower skin. When doing this I would put the skin on and line it up before you push pins in then make sure it it flush using the back end of a screw-driver.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Building the 1:18 scale Star Wars X-Wing from DeAgostini